Content → Command Stations → DCC++

• DCC++
• Signal Setup Example

• DCC++ I/O Setup
• Signal Aspect Numbers
• Signal Aspect Values

• GCA128L pushbutton testboard for I/O units
• G-ASH01 Shield for Arduino Mega

Setting port 30, 32, 34 and 36 to Output type on connector I/O 1:

1. Click on the button I/O 1 to read the current port settings.
2. Set port 30, 32, 34 and 36 to type O.
3. Click on button Save.

Set the port addresses on the Signal Interface Tab:

1. Address RED to 30.
2. Address GREEN to 32.
3. Address YELLOW to 34.
4. Address WHITE to 36.

Select Aspects Numbers as control type, and disable the Accessory checkbox.

The following Signal Details must be set according the wanted behaviour for this example:

1. Set the number of aspects to 4.
2. In the Pattern section set the aspect Numbers and Values.