locoio-multi-en
LocoIO MultiPort
Content → Rocview → Programming → Stationary Decoders
- LocoIO (GCA50)
The LocoIO is capable of reading and writing multiple ports with one command.
This option can be used for signals, turntables and Selection Tables to reduce the amount of required LocoNet commands.
With this tab the MultiPort I/O can be tested.
The required firmware version is 1.49!
Only ports configured as output can be written with a multi port command.
Special remark on LocoIO modules
It is important to power off and on after programming LocoIO units (GCA50 etc).
This is because some changes will only take place after that.
locoio-multi-en.txt · Last modified: 2020/04/02 00:51 by rainerk