locoio-opc-en
Table of Contents
LocoIO OPC
Introduction
| OPC = Operation Code |
Inputs can generate, beside the specific message, an extra LocoNet message which can be defined with this LocoIO dialog tab.
Only 4 byte messages are supported, whereby the last byte(checksum) automatically is added before sending it.
Setup
Port
The LocoIO port to program. Range 1-16.
OPC
The extra OPC must be one of the 4 byte range as documented in the LocoNet-PE.
Argument 1 / 2
Check the 4 byte message documentation, or the LocoNet-PE, for details.
Example
Control an extra switch with a different address and one LocoIO input can be configured like this:
| OPC | Arg1 | Arg2 |
|---|---|---|
| OPC_SW_REQ = 0xB0 = 176 | 67 | 48 |
Port 68, contact 2.
On how the arguments are calculated is documented in the LocoNet PE.
locoio-opc-en.txt · Last modified: 2018/11/12 08:56 by 127.0.0.1