LocoIO I/O

Content → Rocview → Programming → Stationary Decoders

LocoIO (GCA50)
- General | Adresses | Easy Setup | I/O | OPC | MultiPort I/O | Servo

Use the Easy Setup if you are not an expert or only need pre defined settings.

Registers

The register part represents the configuration bytes of the selected port. (Read only) The left column is decimal and the right hexadecimal.
All options on this dialog tab packed in it.
These numbers are solely for information purpose to do a quick I/O setup check.

Configuration
bit 7	0 = input	1 = output
	(0/1)	(0/1)
bit 6	active (low / high)	(contact / block) detector
bit 5	(switch / push button)	(normal / multi)
bit 4	(switch or push button / block detector)	(normal / flashing)
bit 3	(OPC_SW_REP / OPC_SW_REQ)	(continues / pulse) contact
bit 2	block detection switch off (delayed / direct)	reset (software / hardware)
bit 1	not used	not used
bit 0	not used	(high / low) at start up

Value 1
bit 7	0
bit 0-6	low part of port address A1-A7

Value 2
Bit(s)	0 / 1
7	0
6	normal / switch sensor
5	A0 for block detection output contact C1/C2
4	pulse / continues
0-3	high part of port address A8-A11

LocoIO SV's

The opcode OPC_PEER_XFER is used to exchange data between computer and decoder.
John Jabour designed LocoNet module PCB's which also are programable with SV's.

locoio.pdf