User Tools

Site Tools


signal:signal-decodertype-en

Signal Decoder Type

Introduction

The Decoder Type is targeted to special aspect decoders like WeichZwei-Decoder.
Up to 16 addresses can be handled by Aspect Values.
The control is by output commands which are switched on for a duration of 100ms, which can be increased by the Command time.


Interface


Protocol

Select the target protocol, for example "NMRA-DCC".

RED

The base address of the decoder.

Control

  • Aspect numbers

Type

  • Decoder


Details

This example uses 5 aspects:
signal-decoder-values-example.jpg
plan.xml.zip


Aspects

For this example 5.

Number

The range of 0…4 should be set. The order is free and is user dependent.

Value

This example shows the value for the first aspect of this example.

signal/signal-decodertype-en.txt · Last modified: 2023/09/12 15:12 by rjversluis